Welcome!
Tired of chips and swarf getting stuck in your apron gear, binding up your travel?
Just greased and cleaned down there, and already its jam packed with debris?
Try my new Clear PETG apron gear cover today!
Enjoy keeping your grease where it belongs and no more binding, jumping, or dead stopping - ruining your finish or worse.



Precision CNC Laser Cut From: FDA Compliant PETG Cast Sheet

Chemical Resistance– PETG offers superior chemical resistance when compared with many other transparent plastics.
Don't be fooled by the cheaper knock offs - Less quality minded sellers won't tell you what your buying, where later down the road you have a goop mess that reacted with your flood coolant, WD-40, 321, or other oils.



Installation:
You will need A Drill bit, and a Tap for whichever thread you choose, and 3 matching low profile machine screws

Remove your apron and lead screw cover, clean everything well.
Remove the lead screw clamp on rear side of apron ( see pic )
Remove main gear, clean everything, and replace main gear
Place gear cover, and trace holes
Remove cover, Drill and Tap favorite thread ( Be sure your machine screws are low profile head )
Clean everything again!
Pack gear assembly with favorite flavor of grease
Place cover back on, and screw down.
Reassemble apron and adjust lead screw cover
*Note - You may need to adjust the apron with the 2 bolts on the front top, the slots are notched for this adjustment on most lathes*

This cover will fit most, if not all 7x mini lathes from many manufactures - Harbor Freight 7X10 was used as a template

Payment: Paypal, cash, square